The stretch right before lunch wraps up tends to bring a small burst of urgency in a lot of workplaces, as people try to finish one more task before 1:36 pm arrives. This page gives the exact countdown to that point, down to the second, rather than relying on a glance at the clock across the room.
Once the clock reaches 1:36 pm, the countdown does not simply stop at zero — it quietly resets and starts counting towards the same time tomorrow instead. That happens on its own, with no need to refresh the page or reset anything by hand, which makes this a page worth bookmarking rather than one you only use once.
Rosters and shift schedules across a lot of Australian workplaces are written in 24-hour time, so 13:36 is often the figure that actually matters when checking a start time against a printed timetable. This page shows 1:36 pm for everyday reading and 13:36 for lining it up against anything written the other way.
Common questions
Does daylight saving affect the countdown?
Yes, because it reads from your device's own clock, any daylight saving change your device applies automatically is reflected in the countdown without any extra step on your part.
Why does the countdown look different on two devices checked at once?
That usually means the two clocks are not perfectly in sync, or one device has not adjusted for a time zone or daylight saving change. The countdown itself always follows whatever clock it is reading from.
Is there a way to make the countdown count towards a different time?
This particular page is fixed to one target time. Checking a different one just means visiting the matching page built for that specific time instead.
Can this replace an alarm for waking up or getting somewhere on time?
It shows exactly how long is left, but it does not ring or alert you at zero, so it works better alongside an alarm than as a replacement for one.
Cookie policy