Online timer for 38 seconds
Standing beside your surfboard, keep the hose or beach shower moving while the thirty-eight seconds pass. You are close enough to watch salt and sand lift from the deck, rails and fin area rather than leaving the water running unattended. The brief window suits a quick rinse after an Australian beach session, especially when the board only carries a light film of spray.
With several rinses running one after another, each interval can cover a different part of the board without turning the job into a rigid sequence. One may take care of the deck, another the underside, and a final run can clear the fins and leash. Staying beside the board lets you notice where water beads around wax or where sand remains caught near fittings.
As the alert interrupts the rinse, return your attention to the exact patch beneath the water instead of automatically moving on. If the visible salt has gone, stop there; if grains remain around a fin box or leash plug, keep the stream focused briefly rather than restarting the whole rinse. In warm, drying coastal air, checking the surface straight away also helps prevent overlooking a streak that becomes less obvious once the board dries.
Common questions
What can make a surfboard rinse take longer than the set interval?
Heavy sand around the fins, dried salt, or wax that holds grit can extend the rinse. A weak beach tap may also clear residue more slowly, while a clean board after a calm-water session may need less time.
What if the board looks clean before the rinse finishes?
Stop the water and check the rails, fin area and leash plug while staying beside the board. If those spots are clear, there is no need to let the remaining interval run out.
Cookie policy